Standard Resin：
● High Precision & Fast Printing
● Strong Adhesion & Easy to Detach
● Stable Performance & Various Colors

Tough Resin 2.0：
● Exceptional Toughness & Resistant to Breakage
● Strong Elongation & High Flexibility
● High Precision, Minimal Shrinkage

High Speed Resin 2.0：
● High-Activity, Low-Viscosity, Low-Time-Consumption
● Less Prone to Failures and Damages
● Robust Models, Retaining Textures
● Less Odor, More Reliability

Bio Resin：
●Body- Friendly & Sustainable
●CEN Toy Safety Standard EN 71-3
●Precision improved to ±0.1mm
●Minimal Odor
●Exceptional Toughness

• Shake the liquid resin before use.
• Clean the resin tank and the molding platform to keep the bottom of the resin tank in lighttransmission.

• Unscrew the cap and add it to the resin tank according to the equipment requirements.
• Select the correct print parameters and settings for printing.

• After printing, please use the matching tools for post-processing, including blade, diagonalpliers, tweezers, containers, gloves.
• ethanol(≥95%), lactate or isopropyl alcohol cleaning solution.

• A. Remove the printed model from the molding platform with a blade.
• B. Submerge the model in the cleaning solution, rinsed or ultrasonically washed, then takenout and drained; ANYCUBlC Wash and Cure machines are suggested to ensure better effect.
• C. Proper processing, such as removing support, polishing, coloring, etc.

• The ideal condition for storing uncured resin is a cool, dark place at room temperature and protect from light to avoid high temperature or sunlight.
• Suggested operating temperature is 18-35'c, and a low temperature may affect the printing effect, thus, the resin can be properly preheated before use (not more than 60°C).
• If the resin pigment settles, it can be used after stirring or shaking.
• In order to ensure the performance of the resin, please take out the model in time after cleaning to avoid the model soaking in water for a long time.
• To ensure the mechanical properties of the model, please perform post-curing in time after cleaning and drying.
• To ensure the ideal performance of the curable material, it is necessary to control the intensity and time of the light source after curing. Therefore, the following steps are recommended：
• 1. The intensity of mercury lamp or LeD light source is 5-10mW/m?, and the duration is no more than 1 hour (self-regulation)
• 2. The exposure time in the sun (summer) is around 1 hour
• 3. Proximity or long-term exposure under strong light sources such as high-power high-pressure mercury lamps is prohibited
• 4. lt is recommended to print in a dark room or be covered with a lid while printing as resin is a photosensitive material.